Then, place the threaded pin underneath the guide line and push it up through the opening in the middle so that the pointy pin is sticking out underneath.

For anything bigger than that, you’ll need to break out a jigsaw, table saw, or circle-cutting jig for your jigsaw. After lifting out the tray, you will find a foam-backed instruction card, with everything clearly shown in line drawing format. Check the base of the guide line to make sure it’s resting flat on surface you’re cutting and double-check the cutting bit on the Dremel to make sure it lines up with the circle you drew before moving forward.

US Baltimore Armed Privateer Schooner Grecian 1812 (prototype) - Vanguard Models - 1:64 'Zulu' fishing boat , Vanguard Models - 1:64 Fifie' fishing boat, Vanguard Models - 1:64 HMS Flirt 1782, Vanguard Models - 1:64.

Then, further personalize your design by making enhancing adjustments, adding text, and topping it off with animation. Slide the Dremel’s cutting bit through the middle of the plastic housing with the guide line, which is the flat length of metal with the hash marks, at the bottom. After fitting the blade into the tool (yellow 45 degrees) and adjusting its position, I dial the size of circle I want into the cutter, and the cutter is sat on a sheet of masking paper.The box lid contains a line drawing illustration of the circle cutter, and the edge of the box has a unique 16-didgit identifier that you can use to verify that this is a genuine DSPIAE product, and not a counterfeit. These bits come in a variety of styles and sizes, but most of them won’t drive a hole wider than 1 in (2. The NRG also publishes plan sets, books and compilations of back issues of the Journal and the former Ships in Scale and Model Ship Builder magazines.