Mapei 113 UltraColor Plus Cement Grey Grout 2kg

Product Information

Mapei Ultracolor Plus creates water repellent grout joints that have excellent colour uniformity. All colours are resistant to UV rays and atmospheric agents. Kerapoxy Easy Design allows to create floors, walls, worktops etc. in compliance with the HACCP system and the Mapei Ultracolor Plus forms a smooth, compact finished surface with optimum resistance to abrasion, compression and flexural strength, and good resistance to acids with a pH > 3. Floors are ready for light foot traffic after approx. 3 hours. Surfaces grouted with Mapei Ultracolor Plus may be put into service after 24 hours. Basins and swimming pools may be filled up 48 hours after grouting. faster application times and makes it easier to clean from surfaces, with less waste and easier to obtain a good finish; excellent workability, much better than traditional epoxy mortars thanks to its creamy consistency, which guarantees

Mapecolor Metallic is available in Moonlight (similar to platinum), Sahara (similar to gold), Shining (similar Delivery charges vary for the following postcodes and will be delivered between 5-7 working days to the following postcodes: GY, HS, IM, IV41,IV30, IV42, IV44 – 49, IV55, IV56, JE, KA27 – 29, KW1 – 14, KW15 – 17, PA21 – 38, PA20, PA40+, PH9, PH15 – 20, PH32 – 44, PH49, PH50, TR21 – 25, ZE. Before grouting, make sure the installation mortar or adhesive has set and that most of the moisture has evaporated.Applying the grout: Fill the joints with the Mapei Ultracolor Plus mix using a special MAPEI grout float or rubber squeegee, without leaving any gaps or steps. Remove any excess of Mapei Ultracolor Plus from the surface, by moving the float diagonally to the joints while the mix is still fresh. Repairing existing degraded grouts by removing all loose areas and to a minimum uniform depth of 3 mm. Please refer to the Technical Data Sheet for further instructions on how to correctly prepare, apply and finish Ultracolor Grout grout. Pour the catalyst (component B) into the container of component A and mix well until a smooth paste is obtained. We

If the cleaning operation is carried out too soon (the mix is still too wet), some of the mix may be removed from the joints. If grouting is carried out in extremely hot, dry or windy weather, we trowel. Firmly press the tiles/mosaics into the adhesive bed to guarantee good adhesive transfer. Once set, the bond is Due to insurance and health and safety regulations we are unable to transport goods into a Customer’s property

Follow Us:

that the joints are filled right down to the bottom. Remove excess material by passing the edge of the same trowel Kerapoxy Easy Design is not harmed by damp from the substrate, but the joints must not be wet when grouting. recommend using a low-speed electric mixer to guarantee perfect blending, and to avoid overheating of the mix which an area protected from draughts. Interior use may cause the product dispersion in the environment and its deposit on

smooth and compact surface finish which is non-absorbent and easy to clean; it guarantees a high level of hygiene, Where required, add MapeGlitter or Mapecolor Metallic once the blend has been mixed, at a variable ratio depending on Expansion and movement joints on walls and floors must never be filled with Mapei Ultracolor Plus. Use a suitable flexible sealant from the MAPEI range. Always carry out preliminary tests before grouting stone or ground porcelain with a porous or rough surface.If cleaning is carried out a few hours after applying the grout, it may be necessary to leave it standing for longer (at least Wet the grouted surface and emulsify with a cellulose sponge (such as MAPEI sponge). Take care not to drag grout from